Whether a leak or a drip you are experiencing or you simply just want to redo your kitchen, you are probably going to have to learn the art of replacing that kitchen faucet. Of course, it would help you out in the long run learning how to install one as it is a simple task when it comes to ranking home improvement tasks. Using just a few tools and about half an hour, even people that don’t consider themselves handy can manage to change a faucet and not even break a sweat.
The following are some guidelines and a list of things you will need to make installing best rated touchless kitchen faucets easy as pie. The basic tools that you will need are…
- Faucet installation toolkit
- Adjustable wrench
- Phillips screwdriver
The first step is to turn off the cold and hot water lines. Next, you should begin removing that old kitchen faucet and any associated hardware. Go under the counter and use the adjustable wrench and then starting disconnecting faucet hoses from water supply lines and removing the nuts holding the faucets in place, which are located under the surface of the sink.
After removing the faucet, there will be between one to three holes where the faucet once was. The faucet installation kit should match the number of holes you have. Single hose sinks require a spout-based gasket, and then feed the hoses to the faucet through gasket to align it with the faucet’s bottom. For sinks with three holes, use a deck plate. Just like the proves outlined previously, feed hoses through holes and then align with the faucet’s bottom.
Once the deck plate or gasket is attached to the faucet’s bottom, feed hoses through the sink’s center hole. Everything should be properly aligned, with the spout facing forward, with all holes completely covered.
For countertops less than half an inch in thickness, you will have to use the support bracket that’s included in the installation kit. From the sink’s underside, slide bracket over faucet hoses and then hold brackets in place. If your countertop is more than half an inch in thickness, skip this step and move on to the next.
The installation kit comes equipped with a metal circular washer. Slide it over the hoses and all the other hardware.
The next step involves holding hoses to focus on faucet shank. Then you can take nuts from installation kit and then slide upwards. Use fingers and then tighten nuts.
The nut holds the faucet together so it is very important that it be extremely tight with no leakage possible. Place tool over nuts and faucet shanks before then turning to tighten. In some instances, the tool might be too difficult to turn with your hands, and this is why many plumbers use flat-head screwdrivers to twist it as tight as possible.
Interested in bathroom faucet reviews today? Check out kitchenfaucets.reviews.